Specifications

Page 8
For technical questions, please call 1-800-444-3353.
Item 97181
SAFETY OPERATION MAINTENANCESETUP
Operating Instructions
Read the
ENTIRE
IM
P
ORTANT SAFET
Y
INFORMATION
Y INFORMATIONY
section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO
P
REVENT SERIOUS INJUR
Y
REVENT SERIOUS INJURYREVENT SERIOUS INJUR
FROM A
Y FROM AY
CC
IDENTAL
O
P
ERATION:
Turn the
P
ower Switch of the tool off
and unplug the tool from its
ower Switch of the tool off and unplug the tool from itsower Switch of the tool off
electrical
outlet
before performing any procedure in this section.
TO
P
REVENT SERIOUS INJUR
Y
REVENT SERIOUS INJURYREVENT SERIOUS INJUR
:
DO NOT O
P
ERATE WITH AN
Y
GUARD DISABLED, DAMAGED, OR
Y GUARD DISABLED, DAMAGED, ORY
REMOVED.
Mounting Table for Use as Disc Sander
Mounting Table for Use as Disc Sander
NOTE:
The Table (69) may be used as support
for both horizontal and vertical applications.
1.
Insert the end of Table Bar (72)
with Pivot Indicator
(70) into the
Bar
Holder (74).
See Figure
E.
Table (69)
Bar Holder (74)
P
ivot
Indicator (70)
Angle
Adjusting
Knob (75)
Flat Washer (26)
Tighten two Set
Screws (6)
Screws (6)
Screws (6)
Screws (6)
Table Bar (72)
Table Bar (72)
Table Bar (72)
Table Bar (72)
Table Bar (72)
Figure
E
2.
Insert free end of Table Bar (72) into two Mounting
Supports on bottom of Table (69). Tighten the
two Set Screws.
See Figure
E on page 8.
3.
Mount the Pivot Indicator (70) tab to the
Table
(69) using a Hex Bolt (71), Flat Washer
(26)
and Lock Washer (27).
See Figure
F.
4.
Mount Pivot Indicator (70) to the Bar
Holder
(74)
using the Angle Adjusting
Knob
(75)
and Flat Washer
(26). Finger tighten.
See Figure
E
and
Figure
F.
5.
Tighten all fasteners. Make sure the
Pivot
Indicator (70) operates smoothly when
the Angle Adjusting Knob (75) is loosened.
Bolt (71),
Bolt (71),
Flat
Washer
Washer
(26)
and Lock
and Lock
Washer (27)
Washer (27)
P
ivot
Indicator (70)
Figure
F
6.
Slide the Supporting Shaft (76) into Bar Holder
(74).
Align the flat face of the Supporting Shaft with
Set
Screws and tighten securely.
See Figure
G.
7.
Slide the Supporting Shaft (76) into the hole
on side of Machine Body (33) and tighten
Bolt (32).
See Figure
D on page 7
.
Supporting Shaft
Flat Side (76)
Bar Holder
(74)
Figure
G