Sander User Manual

SKU 42966 For technical questions please call 1-800-444-3353 PAGE 6
12. WARNING! The warnings, precautions, and instructions discussed in this
manual cannot cover all possible conditions and situations that may occur. The
operator must understand that common sense and caution are factors which
cannot be built into this product, but must be supplied by the operator.
ASSEMBLY AND OPERATING INSTRUCTIONS
NOTE: For additional references to the parts listed in the following pages, refer to the
Assembly Diagram on page 10.
To Attach A Quick Connector:
1. WARNING! Prior to performing any assembly and/or adjustment proce-
dures, make sure the air supply hose is disconnected from the Sander.
2. Prior to use, the Sander requires the attachment of a Quick Connector (not in-
cluded) into its Hose Adapter (2). To do so, wrap approximately 3” of pipe thread
sealer tape (not included) around the male threads of a Quick Connector. Then,
firmly tighten the Quick Connector into the Hose Adapter. (See Figure A.)
3. Prior to each use, if an automatic oiler is not included in the air compressor hook
up, add two drops of air tool oil (not included) into the Air Inlet fitting of the Sander.
FIGURE A
RECOMMENDED COMPRESSED AIR SYSTEM SETUP
ATTACH
QUICK CONNECTOR
TO SANDER