User Guide

SKU 65706 For technical questions, please call 1-800-444-3353. Page 10
General Operating Instructions
If an automatic oiler is not used, 1. add
a few drops of Pneumatic Tool Oil
to the airline connection before use.
Add a few drops more after each
hour of continual use.
Mark the line you want to cut on the 2.
work material. Since this tool re-
moves 7/32” of material as it cuts, al-
low for this when marking the cut line.
Secure the work piece to the work 3.
table using clamps or other suitable
fasteners.
If you will be using the Laser (37) turn 4.
it on now, by pressing the ON / OFF
Switch (40).
Turn the tool ON before applying it to 5.
the material. Press the safety catch
out of the way, and squeeze the Trig-
ger (9). The tool will begin to operate.
Apply the cutting blades (31-33) to 6.
the edge of the work material, and
begin to cut.
Follow your marked cutting line. If 7.
you are using the Laser (37) the
Laser Beam will help you follow the
cutting line.
Do not support the material by hold-8.
ing it underneath. You can easily cut
your ngers doing this.
When the cut is completed, release 9.
the Trigger, and the tool will cease
operating. If you have used the Laser
(37) turn it OFF by pushing the ON /
OFF Switch (40).
Disconnect the tool from its air supply 10.
and set it aside.
Remove the clamps securing the 11.
work piece to the work table.
If the tool requires more force to 12.
accomplish the task, verify that the
tool receives sufcient, unobstructed
airow (CFM) and increase the pres-
sure (PSI) output of the regulator up
to the maximum air pressure rating of
this tool.
CAUTION! TO PREVENT TOOL
AND ACCESSORY FAILURE, RE-
SULTING IN INJURY:
Do not exceed the tool’s maximum
air pressure rating.
If the tool still does not have sufcient
force at maximum pressure and suf-
cient airow, then a larger tool may
be required.
To prevent accidents, turn off the 13.
tool, detach the air supply, safely
discharge any residual air pressure
in the tool, and release the throttle
and/or turn the switch to its off posi-
tion after use. Clean external sur-
faces of the tool with clean, dry cloth,
and apply a thin coat of tool oil. Then
store the tool indoors out of children’s
reach.