user manual

Page 13For technical questions, please call 1-800-444-3353.SKU 93785
Adjust the Air Compressor’s Pressure 13.
Regulator so that the air output is
enough to properly power the tool,
but the output will not exceed the
tool’s maximum air pressure at any
time. Turn the knob clockwise to
increase the pressure and counter-
clockwise to decrease pressure.
Adjust the pressure gradually, while
checking the air output gauge to set
the pressure.
Use the air tool as needed.14.
After the job is complete, turn the 15.
Power Switch OFF.
Unplug the Air Compressor.16.
Close the in-line Shutoff Valve.17.
Bleed air from the tool then 18.
disconnect the tool.
Turn the Drain Valve, at the bottom 19.
of the Tank, two turns to release any
built-up moisture and the internal
tank pressure. Close the valve after
moisture has drained out. Do not
remove the Drain Valve.
Clean, then store the Air Compressor 20.
indoors.
Emergency Depressurization
If it is necessary to quickly
depressurize the tank, turn the motor
OFF. Then, pull the Safety Valve to
quickly release stored air pressure.
MAINTENANCE AND
SERVICING
Procedures not specically
explained in this manual
must be performed only by a
qualied technician.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn off and unplug the motor
before performing any
inspection, maintenance, or
cleaning procedures.
TO PREVENT SERIOUS
INJURY FROM MOTOR
FAILURE:
Do not use damaged
equipment. If abnormal noise
or vibration occurs, have the
problem corrected before
further use.
Cleaning, Maintenance, and
Lubrication
BEFORE EACH USE,1. inspect the
general condition of the unit. Check
for loose hardware, misalignment or
binding of moving parts, damaged
belts, cracked or broken parts,
damaged electrical wiring, and any
other condition that may affect its
safe operation.
AFTER USE,2. wipe external surfaces
of the unit with a clean cloth.
3. WARNING! If the supply cord
of this unit is damaged, it must
be replaced only by a qualied
service technician.
REV 09j