user manual

Page 14For technical questions, please call 1-800-444-3353.SKU 93785
Maintenance Schedule
Following are general guidelines for
maintenance checks of the unit.
Note: The working environment and
frequency of use can affect how often
you will need to check components
and perform maintenance
procedures.
Daily:
Check oil level.a.
Check for oil leaks.b.
Make sure all fasteners are tight.c.
Drain moisture from air tank.d.
Check for abnormal noise or e.
vibration.
Check for air leaks.f.
*
Inspect drive belt.g.
Wipe off any oil or dirt from the h.
components.
**
Weekly:
Inspect Air Filter.a.
Inspect Oil Breather Plug (15).b.
Monthly:
Inspect Safety Valve.a.
Check/adjust belt tension.b.
Every 6 months or 100 Operation
Hours:
Replace Pump oil.
***
* To check for air leaks, apply soapy water
to joints while the tank is pressurized. Look
for air bubbles.
** To clean the unit, wipe with a damp
cloth, using a mild detergent or mild
solvent.
*** Use Air Compressor Oil only (sold
separately - SKU 95048).
Oil Maintenance
Check the oil periodically for clarity.
Replace oil if it appears milky or if
debris is present, or every 6 months,
or 100 hours of runtime, whichever
comes rst. In harsh environments
such as high heat or high humidity,
you will need to replace the oil more
frequently.
WARNING: Risk of personal injury hazard.
Allow Air Compressor to cool before
changing the oil.
To drain the oil from the Pump
Crankcase:
Place a container under the Oil Drain a.
Bolt (24).
Remove the Oil Breather Plug (15) b.
to allow air ow into the Pump.
Remove the Oil Drain Bolt, allowing c.
the oil to drain into the container.
When the oil is completely drained d.
from the Pump, replace the Oil Drain
Bolt.
Fill the Pump with new compressor e.
oil to the FULL level on the Oil Sight
Glass.
Replace and tighten the Oil Breather f.
Plug.
Clean off any spilled oil.g.
Discard the old oil according to local, h.
state and federal regulations.
Draining Moisture from the Tank
The Drain Valve is located under the
Tank. It must be accessed daily to
release all trapped air and moisture
from the Tank. This will eliminate
condensation which can cause tank
corrosion.
REV 09j