user manual
Page 6For technical questions, please call 1-800-444-3353.SKU 93785
the manufacturer may result in a risk
of injury to persons.
All air line components, including 13.
hoses, pipe, connectors, lters, etc.,
must be rated for a minimum working
pressure of 150% of the maximum
system pressure.
USE OF AN EXTENSION CORD 14.
IS NOT RECOMMENDED. If you
choose to use an extension cord, use
the following guidelines:
RECOMMENDED MINIMUM WIRE
GAUGE FOR EXTENSION CORDS
(120 VOLT)
NAMEPLATE
AMPERES
(at full load)
EXTENSION CORD
LENGTH
25’ 50’ 100’ 150’
0 – 6 18 16 16 14
6.1 – 10 18 16 Do not use.
10.1 – 12 16 16 Do not use.
12.1 – 16 14 12 Do not use.
TABLE A
Make sure your extension cord is in a.
good condition.
Be sure to use an extension cord b.
which is heavy enough to carry the
current your product will draw. An
undersized cord will cause a drop in
line voltage resulting in loss of power
and overheating. Table A shows
the correct size to use depending
on cord length and nameplate
ampere rating. If in doubt, use the
next heavier gauge. The smaller the
gauge number, the heavier the cord.
Industrial applications must follow 15.
OSHA guidelines.
Maintain labels and nameplates 16.
on the compressor. These carry
important safety information. If
unreadable or missing, contact
Harbor Freight Tools for a
replacement.
This product is not a toy. Keep it out 17.
of reach of children.
Operate unit on level surface. Check 18.
oil level daily and ll to marked level if
needed.
People with pacemakers should 19.
consult their physician(s) before
use. Electromagnetic elds in close
proximity to heart pacemaker could
cause pacemaker interference or
pacemaker failure.
WARNING: The brass components 20.
of this product contain lead, a
chemical known to the State of
California to cause birth defects (or
other reproductive harm). (California
Health & Safety code § 25249.5, et
seq.)
By supplying this air compressor 21.
pump, Harbor Freight Tools makes
no representations and accepts no
responsibility for the motor, V-belt,
enclosure or mounting surface not
supplied by HFT which may be
used in the installation. You are
strongly advised to have this pump
properly installed by a qualied
service technician using appropriate
components in good condition.
The warnings, precautions, 22.
and instructions discussed in
this instruction manual cannot
cover all possible conditions and
situations that may occur. It must
be understood by the operator that
common sense and caution are
factors which cannot be built into this
REV 09j