user manual

Page 9SKU 97053 For technical questions, please call 1-800-444-3353.
Connect a compressed air supply hose (not included) to the previously installed 5.
Quick Connector. Then turn on the air compressor, and set its regulator to 90
PSI. Do not exceed 90 PSI. (See Figure E.)
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this manual including all text under subheadings therein
before set up or use of this product.
CAUTION! 1. Prior to using the Sander, make sure to wear ANSI-approved
safety impact goggles, dust mask or respirator, and heavy duty work
gloves.
IMPORTANT: 2. On a DAILY basis, make sure to top off the Sander’s Oil Port with
pneumatic tool oil. To do so, disconnect the tool from its compressed air supply
source and release all remaining air pressure from the tool by pressing the Valve
Lever (1). Use the provided Allen Wrench (49) to unscrew and remove the Allen
Screw (46) located at the top of the tool. Then replace the Allen Screw (do not
over-tighten). (See Figure E.)
Use clamps (not included) or other practical ways to secure and support the 3.
workpiece to a stable platform. Holding the work by hand or against your body is
unstable and may lead to loss of control.
Grip the Sander rmly. Then squeeze the Valve Lever (1) and allow the Pad (38) 4.
to move in its orbital motion to its fullest speed. To adjust the speed (orbits per
minute) of the Sander, rotate the Regulator Set (29). (See Figure E.)
COMPRESSED
AIR SUPPLY HOSE
(NOT INCLUDED)
QUICK
CONNECTOR
(NOT INCLUDED)
REGULATOR SET (29)
FIGURE E
ALLEN SCREW (46)
&
OIL PORT
VALVE LEVER (1)