User's Manual

12. WARNING! The warnings, precautions, and instructions discussed in this
manual cannot cover all possible conditions and situations that may occur. The
operator must understand that common sense and caution are factors which
cannot be built into this product, but must be supplied by the operator.
SAVE THESE INSTRUCTIONS
ASSEMBLY AND OPERATING INSTRUCTIONS
NOTE: For additional references to the parts listed in the following pages, refer to the
Assembly Diagram on page 10.
To Attach A Grit Supply Hose To The Sandblaster Gun:
control the hazard and protect adjacent workers from exposure.
D. Practice good personal hygiene to avoid unecessary exposure to silica dust.
E. Wear washable or disposable protective clothes at the worksite. Shower, and
change into clean clothes before leaving the worksite to prevent contamina-
tion of cars, homes, and other work areas.
F. Use respiratory protection when source controls cannot keep silica exposures
below the NIOSH recommended levels.
G. Provide periodic medical examinations for all workers who may be exposed
to crystalline silica.
H. Post signs to warn workers about the hazard and to inform them about re-
quired protective equipment.
I. Provide workers with training that includes information about health effects,
work practices, and protective equipment for crystalline silica.
J. Report all cases of silicosis to State health departments and to OSHA or the
Mine Safety and Health Administration (MSHA).
1. To attach a grit supply hose - 3/8” - 18 NPT (not included) to the Sandblaster Gun,
wrap approximately 3” of pipe thread sealer tape (not included) around the male
threads at the end of the grit supply hose. Then, firmly tighten the grit supply hose
onto the Intake Connector (34) of the Sandblaster. (See Figure A, next page.)
SKU 92189 For technical questions, please call 1-800-444-3353 PAGE 6