User's Manual

© 2015 CentraLite. All rights reserved.
Data Sheet: 3-Series Smart Garage System (3220) Page 3 of 4
Compatibility
The 3-Series Smart Garage System features out-of-the-box compatibility with any ZigBee HA 1.2-certified hub,
controller, bridge, or platform.
Getting Started
Step 1: Open ZigBee Network for Joining
Using your controller or hub’s interface, enable the
ZigBee network for joining.
Step 2: Plug-In Smart Garage Controller
Plug the Smart Garage Controller into a receptacle
near or inside your garage and it will immediately
begin searching for a network to join.
Step 3: Finish Joining at Hub (optional)
Some hubs and controllers require additional steps
such as naming or categorizing the device.
Step 4: Unplug Smart Garage Controller
Remove the Smart Garage Controller from the
receptacle. It’s now time to mount the device in the
garage.
Step 5: Install Mounting Bracket to Ceiling
Using the included anchors and screws, the controller
bracket should be screwed into the garage ceiling
(directly above the garage door motor) securely,
using all three included mounting screws.
Step 6: Attach Smart Garage Controller
Fit the Smart Garage Controller into the mounting
bracket and twist until it locks into place.
Step 7: Wiring
Using the included control wires, insert the wires
first into the Smart Garage Door quick-connect
terminals, then insert or screw them into the garage
door motor’s control and light terminals. Now plug
the Smart Garage Controller’s power cord into the
ceiling receptacle.
Step 8: Attach Smart Garage Sensor to Door
Using the included hardware (screws or adhesive
tape), install the sensor mounting bracket to the
bottom panel of your garage door. If you have a
non-paneled or solid door, install the mounting
bracket within 18 inches of the floor. Finally, clip the
Smart Garage Sensor into the mounting bracket.
The installation is complete.
Troubleshooting
Step 1: Check Power Status of Smart Garage
Controller.
Ensure that the Smart Garage Controller’s LED status
ring is lit and green. If not, ensure that power is
getting to the receptacle. (Note: if the garage door
motor is powered by the same receptacle as the
Smart Garage Controller, ensure that the garage door
motor is functioning correctly on its own.)
Step 2: Reset and Rejoin Garage Controller
Remove the device from your hub or ZigBee
controller and then open the hub for joining. Then,
using an extension pole or ladder, depress the Smart
Controller’s multi-button (center of the LED ring) for
15 seconds and the Garage Controller will reset and
attempt to rejoin the ZigBee Network.
Note: It is recommended that you complete the joining process before mounting the Smart Garage Controller. The Smart Garage Controller comes pre-joined to its Door Sensor.
Technical Specifications
Electrical
Controller Power: 120 VAC, 60Hz
Sensor Power: 1x CR-2450 Battery
Environmental
Operating Temperature: 0° to 40°C
Shipping / Storage
Temperature: -20° to 50°C
Humidity Range: 0 to 90% R.H.
(non-condensing)
Wireless RF
Protocol: ZigBee HA 1.2
TX Strength: +20 dBm
RF Channels: 16
Range: 50+ ft.