User's Manual

Locating the Thermostat
If this is to replace an existing thermostat, just use the existing thermostat location.
If this is a new install follow these suggestions:
 Locate the thermostat about 5 ft. off the floor away from direct sunlight, lamps, radios, televisions, fireplaces, hot water
pipes, or other heating or cooling sources.
 Do not locate the thermostat near doors to the outside or windows.
 Do not locate the thermostat in a damp area.
 Do not locate the thermostat in an area that lacks air circulation.
Remove Existing Unit
 Switch OFF the electricity to the HVAC unit.
 Remove the cover to the existing thermostat
 Make a note of the terminal location for each wire connected to the thermostat wiring terminals. Wire colors are not stan-
dard so it is important to note the terminal label each wire is connected to on the existing thermostat.
 While removing each wire from the existing thermostat wiring terminal, make sure to secure the wire so that it does not fall
back into the wall.
 Once all wires are removed from the existing thermostat wiring terminal, remove the existing thermostat from the wall.
 Make sure to leave at least 3” of wire for each connection onto the CentraLite thermostat wiring terminal.
 Remove 1/8” insulation from the end of each wire.