User's Manual

Join To Zigbee HA Network
 The CentraLite thermostat is intended to operate as part of a Zigbee HA network.
 The thermostat needs to be joined to the Zigbee HA network after installation.
 The first step in the join process is to make sure the Zigbee HA controller is in it’s join network mode.
 The CentraLite thermostat will attempt to join a Zigbee HA network upon power up or after pressing the Reset button(as long
as it has not already been joined to another Zigbee HA network).
 Upon successfully joining a Zigbee HA network the Zigbee Radio status indicator should illuminate.
 If the indicator does not illuminate then make sure the Zigbee HA system controller is open for joining.
 It may be necessary to have the thermostat leave it’s current Zigbee network. Refer to the programming section.