User Manual

Security
Subscription
Text messages
Users
Website
Wireless network
your Hub start to flash on and off regularly. This
is the one to install now.
Tak e this Button to wher e ever you wish to put it.
As you m ove ar ound your hom e, the light on
your Button may continue to flash, or the light
m ay start to blink twice every few seconds. When
the light is blinking, that means that you are not in
a good location to install your Button, as the radio
signal is not good enough. Don't panic! There are two
reasons the light might do this. One is that you are in
a slightly bad spot for the wireless network ; you may
find that moving the button just a few inches one way
or another is all it takes to get to a better place. If
moving it around does not work , try another location.
If you cannot find a good spot anywhere near there, it
might be that you are out of range of the Hub. Moving
your Lamp nearer to where you want to install this
button might be the answer - read more about
tweaking your system for better wireless network
coverage.
As you position your Button, you should m ake
sure you select a location where the Button light
is flashing continuously. You may wish to place the
Button somewhere, and then watch it for 5 to 10
seconds to ensure that it continues to flash,
confirming that this is a good position where it can
be in constant contact with your Hub. Once you have
found a good spot, fix the Button in place with a
sticky pad (read the instructions fir st!).
If you have any problems with finding a position for
your Button where the light stays flashing, click here
for help. If you have any problems deciding where to
place the Button, or actually fixing it in place, click
here.
Naming the Button
Now you should have successfully positioned the
Button in your home.
On the website, click OK to say you have positioned
your Button; you can now name it in the box. You can
give the Button a name, such as Master Bedroom
Panic Button or Kitchen Doorbell. The name is
entirely up to you; by default your Button is just given
a number, such as Button 1, for the first Button, or
"Doorbell 1" if you decided to mak e it a doorbell.
(Later on, you will have the opportunity to assign the
Installing the Button - Alertme http://wiki.alertme.com/wiki/index.php/Installing_th...
2 of 3 10/10/08 11:31