User's Manual

packaging box, underneath the Hub!
Linking the Hub to your
AlertMe website account
If you have not already logged into the
AlertMe secure website, now would be a
good time to do so! If you have not
registered on the site, you will need to
do this now (it is likely that you will
have registered when you ordered your
Kit, though). There is more information
about registration here. If you are
having problems with the secure
website, click here.
Once you are logged in, it's tim e to
connect your Hub with your secure
website account. On the website, you
should automatically be tak en to the
right place in the install process, but if
not, go to the MySettings section (by
clicking on the icon at the top right).
You should now be in the online install
walk through. There will be a few
screens of information, which you
should read, before you need to do
anything.
You will, then, see a box where you
should type in your Hub ID Number.
This number is printed at the back of
the Hub, just above where the cables
plug in. The Hub ID consists of 3 letters
and 3 numbers. Once your Hub is
flashing red, on and off and on again,
it is ready to connect. Type the Hub ID
into the box on the website, and click
OK.
If your Hub is flashing oddly and
only on one side, click here for
advice.
If all has gone smoothly, the website
should now tell you that it is
communicating with your hub. If not,
click here for help.
Installing the Hub - Alertme http://wiki.alertme.com/wiki/index.php/Installing_t...
3 of 4 10/10/08 11:34