User Manual

You have the choice of positioning the Motion Sensor flat on one wall, or on a corner between two walls.
These two options are illustrated here, which also shows the "right way up"!
You should also try to follow our general Accessory positioning guidelines.
If you are having problems positioning it, try reading our help on positioning.
I can't see a flashing light on it
The light, when flashing, is in the position of the green dot here:
When you first put the battery in, you should expect to see the Motion Sensor light blink twice every few
seconds; the light will go out once the Motion Sensor is communicating with the Hub. The light will come on
again when this Motion Sensor is selected for placement on the website; then, it will flash regularly once a
second (if it is in a good position for the Accessory to be installed), or it will blink twice every few seconds (if it
is not in a good position). If you aren't placing this Motion Sensor, it most likely will not be flashing its light.
How do I stick it up?
You have the choice of positioning the Motion Sensor flat on one wall, or on a corner between two walls.
These two options are illustrated here.
Firstly, make sure you know how to use the sticky pads! If you haven't already read the instructions for these,
do so now here.
Peel a sticky pad off the backing sheet, put it onto the back of the Motion Sensor and press firmly for a few
seconds. Then, peel off the printed part of the cover sheet off the pad you just stuck down, and press the
Motion Sensor against the surface you want to stick it to firmly for a few seconds. Done!
What does the flashing light mean whilst I'm installing it?
When this Motion Sensor is selected for placement on the website it will flash regularly once a second (whilst
it is in a good position for the Accessory to be installed), or it will blink twice every few seconds (if it is not in a
good position).
You should hold the Motion Sensor still in the place you want to install it for about 5 seconds. If the light
flashes regularly once a second all that time, it is a good spot to install it. If it doesn't, you should try moving
the Motion Sensor somewhat - read our tips here.
I can't get it to flash regularly where I want to install it
Check you have followed our Accessory positioning guidelines. For help with getting Accessories to
communicate with your Hub all around your home, click here.