User Manual

Using the sticky pads
We provide plenty of sticky pads for you to fix AlertMe accessories around your home. These are special pads
from TESA. Please note that sticky pads only come in two types - big (most of your Accessories) and small (for
the magnet of your Door/Window Sensor). You don't need to worry about getting mixed up about which are
for what accessories! :)
Contents
1. Why use the sticky pads provided, rather than any others?
2. Using the Sticky Pads - the Movie
3. Sticking an Accessory in place
4. Removing an Accessory
5. If you have any problems...
Why use the sticky pads provided, rather than any others? Because the special AlertMe-provided sticky pads
not only secure your Accessories firmly to your home, but also can be removed cleanly without damaging your
decor, if you follow the instructions!
Using the Sticky Pads - the Movie
Click here (http://www.alertme.com/videos/stickies.mov) to watch a Quicktime movie about how to use the
sticky pads.
Sticking an Accessory in place
There is a sheet of sticky pads in the box with each Accessory. This should mean you have enough to stick up
the Accessory, with a couple left over in case you make a mistake, or want to move the Accessory later.
Make sure that both the Accessory you want to stick in place, and the surface you are sticking it to, are both
clean and dry. When you are picking a location, try to make sure you stick the Accessory down so that you can
reach the clips that enable you to open the case and replace the battery! If you are installing a Button, bear in
mind that you can instead use screws to fix this to your home if you prefer (read more here).
Peel a sticky pad off the backing paper and place onto the back of the Accessory, pressing firmly for 5 seconds.
Do not remove the clear strips from the end of the tab.
Then, simply peel off the printed cover sheet, and stick the Accessory to your wall, doorframe, etc, making
sure that the tab is somewhere you can reach it later on, and where you can pull it along the surface away
from the Accessory for a few cm at least (see below for why you should do this!). Hold in place, pressing firmly
down, for 5 seconds.