User's Manual

CGVIEW0917V1

Hive View

IC Compliance

This device complies with Industry Canada licence-exempt

RSS standard(s).

Operation is subject to the following two conditions:

(1) This device may not cause interference, and

(2) This device must accept any interference,

including interference that may cause undesired

operation of the device.

IC Compliance

Le present appareil est conforme aux CNR d’Industrie

Canada applicables aux appareils radio exempts de licence.

L’exploitation estautorisée aux deux conditions suivantes:

(1) l’appareil ne doit pas produire de brouillage, et

(2) l’utilisateur de l’appareildoit accepter tout

brouillageradioélectrique subi, mêmesi le brouillage

est susceptible d’en compromettre le fonctionnement.

RF Exposure Information:

This device meets the government’s requirements for exposure to radio

waves. This device is designed and manufactured not to exceed the emission

limits for exposure to radio frequency (RF) energy set by the Federal

Communications Commission of the U.S. Government. The exposure

standard for wireless devices employs a unit of measurement known as

the Speciﬁc Absorption Rate, or SAR. The SAR limit set by the FCC / by

the RSS-102 is 1.6 W/kg. Tests for SAR are conducted using standard

operating positions accepted by the FCC with the device transmitting at

its highest certiﬁed power level in all tested frequency bands. Although the

SAR is determined at the highest certiﬁed power level, the actual SAR level

of the device while operating can be well below the maximum value. This is

because the device is designed to operate at multiple power levels so as to

use only the power required to reach the network. In general, the closer you

are to a wireless base station antenna, the lower the power output. While

there may be dierences between the SAR levels of various devices and

at various positions, they all meet the government requirement.

This product is compliance to FCC RF Exposure requirements and refers

to FCC website:

https://apps.fcc.gov/oetcf/eas/reports/GenericSearch.cfm

Search for FCC ID: WJHHCI001

This equipment should be installed and operated with minimum distance

5 mm between the radiator and

your body.

PAGE 1
RF Exposure Information: This device meets the government’s requirements for exposure to radio waves. This device is designed and manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal Communications Commission of the U.S. Government. The exposure . of measurement known as standard for wireless devices employs a unit the Specific Absorption Rate, or SAR. The SAR limit set by the FCC / by the RSS-102 is 1.6 W/kg.
PAGE 2
RF Exposure Information: exposure limits in IC RSS-102 and had been tested in accordance with the measurement methods and procedures specified in IEEE 1528. This equipment should be installed and operated with minimum distance 5 mm between the radiator and your body. This device and its antenna(s) accordance with the instructions, may cause harmful interference to radio occur in a particular installation.