User Manual

remove this if you have one!) If the
light does not turn on at all, then
click here for help.
The Motion Sensor
To put in a battery, squeeze the
tabs on opposite sides of the
sensor, and lift off the front (see
here for pictures). The battery is
supplied by AlertMe in the Motion
Sensor box. Clip the back on the
sensor again when you have put
the battery in. If the light does not
turn on at all, then click here for
help.
The Alarm Detector
To put in a battery, squeeze the
tabs on opposite sides of the
sensor, and lift off the front (see
here for pictures). The battery is
supplied by AlertMe in the Alarm
Detector box. Clip the back on the
detector again when you have put
the battery in. If the light does not
turn on at all, then click here for
help.
The Door/Window Sensor
To put in a battery, squeeze the
tab mark ings on opposite sides of
the big part of the sensor, and use
them to lift off the front (see here
for pictures). The battery is
supplied by AlertMe in the
Door/Window Sensor box. Clip the
back on the sensor again when
you have put the battery in. If the
light does not turn on at all, then
click here for help.
The Keyfob
To put in a battery, insert a small
flat-bladed screwdriver into the
slot at the keyring end, and lever
up the top of the case, then slide it
Starting up the Accessories - Alertme http://wiki.alertme.com/wiki/index.php/Starting_up_...
4 of 5 10/10/08 11:33