User Manual

From Alertme
User Guide front page
Recent changes
List of all pages
How to use this Guide
Getting Started
Quick Answers
Personalising your system
Using AlertMe
Troubleshooting
About AlertMe
Categories:
Accessories
Batteries
Button
Emails
Emergency alarm
Friends
Green
Help
History
Home network ing
Home safety
Hub
Installation
Intruder alarm
Keyfob
Kit
Lamp
Legal
Messages
The Hub does not
seem to connect to
AlertMe
From Alertme
Make sure that your Hub is connected to your
broadband router via an Ethernet cable.
Make sure that the Hub is plugged into mains
power and that the mains socket is turned on!
Make sure the hub power cable is securely
plugged in.
Wait a few minutes - som etim es this stage
takes a little while, as AlertMe and your
home set up secure comm unications.
Your Hub will light up various colours after you
plug it in for the first time. It is ready to connect
to our servers when it is flashing red, on and off
and on again.
If you've waited over 5 minutes, please
Contact AlertMe for support and have your
Hub ID to hand.
If your hub is glowing pink continuously
...then you may need to reset it. You can reset
your Hub using a paperclip or similar pointy
object. There is a small hole on the bottom of the
Hub (smaller than the other holes! see the
pictures here - the reset switch is shown at the
bottom right). Insert your paperclip to press the
recessed reset button. The Hub should stop
glowing for a moment and then light up again;
T he Hub does not seem to connect to AlertMe - Al... http://wiki.alertme.com/wiki/index.php/T he_Hub_do...
1 of 2 10/10/08 12:18