User Manual

Personalisation
Phone calls
Purchasing
Security
Subscription
Text messages
Users
Website
Wireless network
It work s by listening out for the noise of a
smoke alarm, or other alarm, going off; it
should be installed within 5cm of the alarm
it is to listen to. There's more info here.
How do I start it up?
To put in a battery, squeeze the tabs on
opposite sides of the sensor, and lift off the
front (see here for pictures or here for a
movie). The battery is supplied by AlertMe
in the Alarm Detector box. Clip the back
on the sensor again when you have put the
battery in. The light should then blink
twice every few seconds for a while; this
will stop once the Alarm Detector is
communicating with the Hub. If the light
does not turn on at all, then click here for
help.
If it stops flashing, but does not appear on
the website as an icon, wait a few minutes.
If that doesn't work , try taking the battery
out for 10 seconds, replacing it, and
waiting another few minutes. If it still
doesn't appear, click here.
Where should I put it?
The Alarm Detector is a way of
connecting your existing smoke or
carbon monoxide alarm s to Aler tMe.
To add an existing alarm to the
AlertMe system, sim ply install an
Alarm Detector im m ediately next to
the alarm . When an alarm goes off, it
will mak e a sir en noise as usual, but
in addition you can receive phone calls
or text m essages through Aler tMe. You
should position your Alarm Detector within
Getting started with the Alarm Detector - Alertme http://wiki.alertme.com/wiki/index.php/Getting_star...
2 of 5 10/10/08 11:59