User Manual

5cm of your existing smok e alarm, sticking
it next to the existing alarm on the ceiling
(or, possibly, wall).
You should also try to follow our general
Accessory positioning guidelines.
If you are having problems positioning it,
try reading our help on positioning.
I can't see a flashing
light on it
The light, when flashing, is in the position
of the green dot here:
When you first put the battery in, you
should expect to see the Alarm Detector
light blink twice every few seconds; the
light will go out once the Alarm Detector is
communicating with the Hub. The light
will come on again when this Alarm
Detector is selected for placement on the
website; then, it will flash regularly once a
second (if it is in a good position for the
Accessory to be installed), or it will blink
twice every few seconds (if it is not in a
good position). If you aren't placing this
Alarm Detector, it most likely will not be
flashing its light.
How do I stick it up?
Firstly, mak e sure you know how to use the
sticky pads! If you haven't already read the
instructions for these, do so now here.
Peel a sticky pad off the backing sheet, put
Getting started with the Alarm Detector - Alertme http://wiki.alertme.com/wiki/index.php/Getting_star...
3 of 5 10/10/08 11:59