User Manual

I can't see a flashing
light on it
When the Button flashes its light, the
whole of the orange ring on the front
will light up!
When you first put the battery in, you
should expect to see the Button light
blink twice every few seconds; the light
will go out once the Button is
communicating with the Hub. The light
will come on again when this Button is
selected for placement on the website;
then, it will flash regularly once a
second (if it is in a good position for the
Accessory to be installed), or it will
blink twice every few seconds (if it is
not in a good position). If you aren't
placing this Button, it most lik ely will
not be flashing its light.
How do I stick it up?
Firstly, mak e sure you know how to use
the sticky pads! If you haven't already
read the instructions for these, do so
now here.
Peel a sticky pad off the backing sheet,
put it onto the back of the Button and
press firmly for a few seconds. Then,
peel off the printed part of the cover
sheet off the pad you just stuck down,
and press the Button against the
surface you want to stick it to firmly for
a few seconds. Done!
With the Button, you have the
alternative of using screws to fix the
Button to a wall. There are special
guide circles on the back part of the
Button where you could punch through
in order to use screws; these should be
obvious if you lift off the front of the
Getting started with the Button - Alertme http://wiki.alertme.com/wiki/index.php/Getting_star...
3 of 5 10/10/08 11:59