User Manual

Personalisation
Phone calls
Purchasing
Security
Subscription
Text messages
Users
Website
Wireless network
Positioning the Lamp in your
home
The Lamp you are about to install
should currently be near to your Hub.
On the walkthrough page on AlertMe's
secure website you should now be able
to see all of the Lamps you have,
including the one you are about to
install. If you drag a Lamp icon on
the website to the box on the r ight
hand side, you should see the Lamp
in your home near your Hub start to
flash on and off regularly. This is
the Lamp to install now, if you have
m ore than one.
If your Lamp does not flash at all,
please read our help page her e.
Bear in mind that although your Lamp
has a battery in to keep it running when
the mains power goes out, it may not
yet be fully charged if you only recently
plugged in the Lamp for the first time. If
the light goes out it may be lack of
power, not that you are out of range.
Try plugging in the mains and waiting
5-10 seconds rather than watching the
light as you walk around your home, to
position the Lamp.
You can unplug your Lam p now and
carry it, with its power supply, to
where ever you wish to put it. As you
m ove around your home, your lam p
m ay continue to flash, or the light
m ay go out. When the light is blink ing
twice every few seconds, that means
that you are not in a good location to
install your Lamp, as the radio signal is
not good enough. Don't panic! There
are two reasons the lamp might do this.
One is that you are in a slightly bad
spot for the wireless network; you may
find that moving the sensor just a few
inches one way or another is all it
Installing the Lamp - Alertme http://wiki.alertme.com/wiki/index.php/Installing_th...
2 of 4 10/10/08 11:32