User Manual

I can't see a flashing
light on it
The light, when flashing, is in the
position of the green dot here:
When you first put the battery in, you
should expect to see the Door/Window
Sensor light blink twice every few
seconds; the light will go out once the
Door/Window Sensor is communicating
with the Hub. The light will come on
again when this Door/Window Sensor is
selected for placement on the website;
then, it will flash regularly once a
second (if it is in a good position for the
Accessory to be installed), or it will
blink twice every few seconds (if it is
not in a good position). If you aren't
placing this Door/Window Sensor, it
most lik ely will not be flashing its light.
How do I stick it up?
Firstly, mak e sure you know how to use
the sticky pads! If you haven't already
read the instructions for these, do so
now here.
Peel a sticky pad off the backing sheet,
put it onto the back of the
Door/Window Sensor and press firmly
for a few seconds. Then, peel off the
printed part of the cover sheet off the
pad you just stuck down, and press the
Door/Window Sensor against the
surface you want to stick it to firmly for
a few seconds. If you lik e, you can use
Getting started with the Door/Window Sensor - Alertme http://wiki.alertme.com/wiki/index.php/Getting_star...
4 of 6 10/10/08 11:59