User Manual

From Alertme
User Guide front page
Recent changes
List of all pages
How to use this Guide
Getting Started
Quick Answers
Personalising your system
Using AlertMe
Troubleshooting
About AlertMe
Categories:
Accessories
Batteries
Button
Emails
Emergency alarm
Friends
Green
Help
History
Home networking
Home safety
Hub
Installation
Intruder alarm
Keyfob
Kit
Lamp
Legal
Messages
Personalisation
Phone calls
Purchasing
Security
Subscription
Text messages
Users
Website
Wireless network
Using the sticky pads
From Alertme
We provide plenty of sticky pads for you to fix AlertMe accessories around
your home. These are special pads from TESA. Please note that sticky pads
only come in two types - big (most of your Accessories) and small (for the
magnet of your Door/Window Sensor). You don't need to worry about getting
mixed up about which are for what accessories! :)
Contents
1 Why use the sticky pads provided, rather than any others?
2 Using the Sticky Pads - the Movie
3 Sticking an Accessory in place
4 Removing an Accessory
5 If you have any problems...
Why use the sticky pads provided, rather than any others?
Because the special AlertMe-provided sticky pads not only secure your
Accessor ies firm ly to your home, but also can be rem oved cleanly
without damaging your decor , if you follow the instructions!
Using the Sticky Pads - the Movie
Click here (http://www.alertme.com/videos/stickies.mov) to watch a Quicktime
movie about how to use the sticky pads.
Sticking an Accessory in place
There is a sheet of sticky pads in the box with each Accessory. This should
mean you have enough to stick up the Accessory, with a couple left over in
case you make a mistake, or want to move the Accessory later.
Mak e sure that both the Accessory you want to stick in place, and the
surface you are sticking it to, are both clean and dry. When you are
picking a location, try to m ake sure you stick the Accessory down so
that you can reach the clips that enable you to open the case and
replace the battery! If you are installing a Button, bear in mind that you
can instead use screws to fix this to your home if you prefer (read more here).
Peel a sticky pad off the back ing paper and place onto the back of the
Accessory, pressing firm ly for 5 seconds. Do not remove the clear strips
from the end of the tab.
Then, simply peel off the printed cover sheet, and stick the Accessory to
your wall, doorframe, etc, m aking sure that the tab is som ewher e you
can r each it later on, and where you can pull it along the surface
away from the Accessory for a few cm at least (see below for why you
Using the sticky pads - Alertme http://wiki.alertme.com/wiki/index.php/Using_the_st...
1 of 4 10/10/08 12:16