User Manual

4
7 6
2
Unpack your kit. You will also need access
to your broadband router and computer
Plug in the lamp and insert batteries into the
other accessories
Test your AlertMe system Following the web instructions, place
accessories around your home
3
Plug your hub into your broadband router
and follow the web instructions at alertme.com
5
Attach sticky pads to your accessories
1
1
/
2
Please leave at least 1
1
/
2
hours for installation
Press for 5
seconds
Hold for 5
seconds
Some accessories may require 2 sticky pads
!
Squeeze the tabs on the side of the accessory to open
!
Once the battery is in place, carefully push together the
two sides of the accessory
!
Insert the keyfob tool into the slot by the keyring and slide
the top of the accessory back.
!
Distance between alarm and sensor - max 5cm
!
Distance between sensors - max 5mm
!
Make sure the indentations on both sensors are facing
each other
!
To remove the sticky pads, pull the exposed tabs away
while holding the accessory firmly in place.
!
Point me so the only movement I see
is people, not pets!
!
Connect your hub to your broadband router with the ethernet cable
provided. Connect it to mains power using the power cable provided.
!
Wave your hand in front of the motion sensor.
!
Check the keyfob arms and disarms your system
!
Open windows and doors to check your sensors.
!
Side 2 without tab:Layout 1 7/12/07 13:43 Page 1