User guide

Centurion Sliding Gate Operators User Guide - 15
!
If the gate is closing, it will immediately stop and reopen.
!
If the transmitter or intercom gate release pushbutton is pressed while the beam is
broken, or the loop activated, the gate will remain open. The auto-close time will
restart its countdown.
HOLIDAY LOCKOUT (OPTIONAL)
A keyswitch can be connected to the gate system that will allow the system to be
totally immobilised. The keyswitch is mounted with access from the outside of the
property. When the keyswitch is OFF, the gate system will shut down and it will not be
possible to operate the gate. When the keyswitch is ON, the gate system will operate
normally.
This is an added security feature should the property be unattended for an extended
length of time.
The holiday lock out facility could also be activated using a keypad, radio receiver with
a latching output or an ON/OFF toggle switch.
COURTESY LIGHT TIMER (OPTIONAL)
If a 220V power supply is available at the gate, timed courtesy lights can be
connected through the controller. Each time the gate is opened, the lights will switch
on for a period of time and switch off. The time can be adjusted up to 40 minutes in 10
second increments.
A courtesy light pushbutton can be mounted inside the house (typically on the
intercom) allowing convenient control of the lights. By pressing the pushbutton.
By pressing the courtesy light pushbutton (if fitted), momentarily the light will switch
on for the light timer period and automatically switch off. By pressing and holding the
pushbutton down for 3 seconds the lights will switch on and remain on. The status
LED (if fitted) will flash once every 2 seconds to confirm this. To switch off the lights
press the pushbutton momentarily. If courtesy lights are fitted to the controller, and the
pedestrian keyswitch is operated, the courtesy lights will flash for 5 seconds before
the gate opens. This warns the pedestrian that the gate will open within 5 seconds
allowing time to remove the key and stand back from the gate.
PRE-FLASHING
The courtesy light can be programmed to flash for a period of time before the gate