Installation manual

Cabling RequirementsCabling RequirementsCabling Requirements
Page 14
1. 220V AC mains cable via mains isolator
2
switch (3 core LNE 0,5mm )*†,
Or
Low voltage 16V AC battery charger
2
supply (2 core 1,5mm )†.
2. Intercom cable (n1 + 6 core) to house.
3. Slave motor cable (if required) (3 core
2 2
2,5mm + 3 core 0,5mm multistranded).
2
4. Radio receiver cable (3 core 0,5mm
multistranded).
5. Pedestrian key switch (if required) (2
2
core 0,5mm multistranded).
6. Infrared beams or safety edge (if
2
required) (3 core 0,5mm multistranded)
2
7. Intercom cable (n2+2 core 0,5mm
multistranded) to gate station.
LEGEND
T
o dwelling
Mains
isolator
switch
* Increase cable thickness if pillar lights are to be installed.
† Screened cable is always recommended to provide better protection against lightning - earth one end of
screening.
Figure 5 Cabling Requirements
* Increase cable thickness if pillar lights are to be installed.
† Screened cable is always recommended to provide better protection against lightning - earth one end of
screening.
n1 = number of cores required by intercom. n2 = number of cores required by intercom.