Installation manual

Page 26
Connecting Arm
Close gate to
extend the
connecting arm
NB. Hinge points
must be in a straight
line when gates are closed
Drive Arm
Drive Arm
Clamp
Gate closed and aligned
GATE LEAF IN CLOSED POSITION
Figure 22 Align Gates
Figure 20 Assemble Clamp to Drive Arm (R3 only)
R3 R5
Figure 21 Assemble Clamp to Drive Arm (R5 only)
19. Once a satisfactory gate opening has been achieved, the connecting arm must be fully tightened:
Disconnect the connecting arm from the gate bracket. Remove the bushes from the front end of
the connecting arm. Using a large screwdriver or similar lever, tighten the ski-pole lock using half-
turns until it is as tight as possible and aligned with the gate bracket. Replace the bushes and
reconnect the connecting arm to the gate as shown in Fig. 19.
20. Apply the two warning decals supplied to the inward and outward facing sides of the gate frame
about 1.2m above ground at the non-hinged end of the gate.
Clamp
Drive Arm
M12 Bolt
M12 Washer
Wedge
Clamp
Drive Arm
M12 Bolt
M12 Washer
Wedge