Installation manual

8. Repeat the procedure for the other motor in a
double swing system.
9. Return the origin tool to its storage position on
the upright pillar and close the override dust
cover.
10. With the gates still in manual mode, move the
gates to the ½ way open position, and
unscrew the manual release until the top of
the screw is flush with the top of the shaft.
(The gearbox does not have to be engaged
with the drive arm, when in the ½ way open
position.)
Get into programming
mode
11. Remove ALL power from the controller, i.e.
charger plug and battery.
12. Fit the SET link to the SET pins as shown in
Fig. 28.
13. Reapply power by reconnecting the charger
plug, and then the battery to the controller.
14. Immediately after reconnecting the power, the
STATUS light will flash 5 times. The SET and
L2 lights will now be on. You are now in
programming mode.
(See Set-up Troubleshooting Guide step 14).
Figure 28 Controller SET Link & Programming LED's
Fit SET
Link Here
L1 and L2
Indicator LED's
STATUS
Indicator LED
SET
Indicator LED
Figure 27 Twist Setup Tool Until Marks Align
Setup Tool
Manual Release
Mechanism
Page 28
Figure 25 Setup tool in stored position
Figure 26 Fit Setup Tool into Release Mechanism
Setup Tool
Manual Release
Mechanism