Installation manual

The manual release mechanism is used to disengage the output shaft from the motor, thus making it
possible to open or close the gates manually without turning the motor or any other internal parts.
Normal Operation
1. Flip over the controller enclosure. Open the override dust cover as shown in Fig. 31.
2. Insert the 6mm Allen key supplied into the release mechanism (Fig 25).
3. Turn the Allen key clockwise to release the mechanism as shown in Fig 25.
or
Turn the Allen key counter clockwise to engage the release mechanism.
4. Remove the allen key.
5. Close the override dust cover.
Page 43
Manual Release MechanismManual Release MechanismManual Release Mechanism
Figure 31 Manual Release Mechanism
Setup Tool
Allen Key
Figure 32 Manual Release Operation
Procedure to Programme Controller BackProcedure to Programme Controller Back
to Factory Default Settingsto Factory Default Settings
Procedure to Programme Controller Back
to Factory Default Settings
1. Remove all power (Power supply and battery ).
2. Fit the "SET" link.
3. Connect "PED" and "FRX" to "COM".
4. Reconnect all power. (L1 AND L2 will illuminate).
5. Remove all power (Battery and power supply).
6. Remove the "SET" link and disconnect "PED" and "FRX" from "COM".
7. The card is now programmed to default settings as shown in table 2 (see page 47) (Gate end points
are not affected).