Installation manual

Read and understand all safety instructions Page 5
Connect all wiring: Page 27
Set the gate origin: Page 27
Release the manual override and close the gate(s)
Use origin tool and line up marks
Open gate ½ way and unscrew the manual release
mechanism.
Get into programming mode: Page 28
Remove all power.
Fit the SET link.
Reapply power.
Select master or slave set-up: Page 29
Press and hold TEST, release after 1 flash of L1.
Press and hold TEST, release after 1 or 2 flashes
(1=master, 2=slave).
Set the gate limits: Page 29
Press and hold TEST until gate is closed, release.
Press and hold TEST until gate is open, release.
Press and release TEST. (The MASTER gate will close and
open to pedestrian. The SLAVE gate will close slightly).
Set additional features: (If required) Page 30
Exit programming mode:
Remove the SET link.
Perform installation hand over Page 51
Action
Electrical Setup
Fast TrackFast TrackFast Track
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
Step 1
Page 7