Installation manual

SPECIFICATION (continued)
The actual components supplied may vary depending on the model purchased.
Product IdentificationProduct Identification
Figure 2 Linkage Hardware Kit
1
Page 10
1. R3/R5 Linkage Hardware Kit
2. Connecting Arm
3. Drive Arm
4. End Cap
5. Drive Arm Clamp
6. Wedge
7. M10 Washer
8. M12x65 Bolt
9. Clevis Pin
10. Gate Bracket
11. Padlock with key
Maximum wind speed for which the operator will open the gate
Gate Length:
R3 - Max. Allowable Leaf Mass:
Gate Length:
R3 - Max. Allowable Leaf Mass:
400kg
400kg
1,5m
1,5m
2,0m
2,0m
2,5m 3,5m3,0m
400kg
300kg
320kg
225kg 160kg
-Electric lock recommended;# -When installed in recommended positions, and collision sensitivity set to LOW.
11
9
10
4
3
2
8
7
6
5
Maximum wind speeds for which the operator will open the gate:
Perpendicular or Parallel Wall Mount & Outward Opening
Standard Inward Opening or Limited Space Installation
Maximum gate length & mass for Installation:
R3: For a 1,8m high gate, 25% coverage#:
R3: For a 1,8m high gate, 100% coverage#:
R3: For a 1,8m high gate, 25% coverage#:
R3: For a 1,8m high gate, 100% coverage#:
75km/h
37km/h
50km/h
25km/h
600kg
127km/h
64km/h
600kg
89km/h
44km/h
44km/h
22km/h
34km/h
17km/h
54km/h
27km/h
34km/h
17km/h
600kg
93km/h
46km/h
600kg
63km/h
31km/h
38km/h
19km/h
R5 - Max Allowable Leaf Mass:
R5: For a 1,8m high gate, 25% coverage#:
R5: For a 1,8m high gate, 100% coverage#:
R5 - Max. Allowable Leaf Mass:
R5: For a 1,8m high gate, 25% coverage#:
R5: For a 1,8m high gate, 100% coverage#:
510kg
74km/h
37km/h
260kg
56km/h
28km/h
360kg
64km/h
32km/h
Figure 3 Product Identification
Page 11
1. Baseplate 7. Gearbox
2.* Battery (7 A/H) 8.* Charger ( )
3. Geared DC Motor 9.* Enclosure Uprights
4.* Master Controller (CP75) 10. Warning Decal
5. Slave Interface Card (CP75B) 11. Wall Mount Bracket (Version 2)
6.* Controller Enclosure 12. Pedestal (Version 2)
CP84ER5V01
* Not fitted to a slave motor in a double leaf gate system.
† Pedestal and wall mount installations require different connecting arms. Be sure to use the correct connecting
arm for the particular installation type.
1
2
3
6
4
9
8
7
21
10
12
11
5