Installation manual

NAME
COLOUR ON OFF REMARKS
Table 1 LED Indicator Light Description & Purpose
Page 46
LED Indicator LightsLED Indicator Lights
The controller is fitted with diagnostic lights (LEDs) that assist with the set-up and maintenance of the gate.
Table 1 provides a description and purpose of the indicator lights. Refer to page 46 for location.
During Normal Operation
STATUS
(During
normal
operation)
Red
Gate fully open Gate fully closed 1 Flash/sec - Pillar light on permanently
2 Flashes/sec - Charging failure
3 Flashes/sec - Battery low detection
4 Flashes/sec - Collision detector operated
5 Flashes/sec - Microprocessor reset
L1 Red
Master origin diagnostic
(Changes state to indicate origin status)
L2 Red
Slave origin diagnostic
(Changes state to indicate origin status)
CHARGER
ON
Green
Battery charging
No charge voltage
present.
TRG
Red
Signal present No signal
N/A
IRB
Green
Safeties clear
Safeties obstructed
N/A
Signal present
No signal
FRX
Red
N/A
Signal present No signal
PED
Red
N/A
LCK Green
System ready to
operate
System locked
N/A
Signal present
No signal
SET
Red
N/A
During Programming Mode
STATUS
Red
The number of flashes correspond to the
STATUS or COUNT value being set.
L1
Red
If LED2 also on,
system reset to
factory default.
The number of flashes corresponds with
the FEATURE number being selected
L2 Red
System in programme
mode.
If L1 also on,
system reset to
factory default.
FEATURE
DESCRIPTION
Auto-close
Auto-close Time
Gate Limit Settings
-
See detailed instructions on page 29
1
2
3
STATUS or COUNT
DESCRIPTION
-
ON
15 seconds (Default)
1 Flash = 1 second
-
OFF (Default)
FEATURE
NUMBER
COUNT
VALUE
CP75 Controller FunctionsCP75 Controller Functions
Page 47
-
-
Mode of Operation
Pedestrian Auto-close
4
5
-
STANDARD (Default)
1 Flash = 1 second
5 seconds (Default)
-
CONDOMINIUM
PIRAC
REVERSING
Table 2 Controller Functions Menus and Submenus
Delay on master closing
Collision Counter
Leaf Delay Select
Leaf delay time /
Solenoid Strike Time
Delay on slave opening
1 Flash = 1 second
1 Flash = 1 count
4 counts (Default)
2 seconds (Default)
Delay on slave opening & master closing
Delay off (Default)
-
-
-
-
-
12
13
14
Preflashing
Preflash Time
Collision Sensitivity
Auto-close Override
Positive Close Mode
MODE 1
HIGH (Default)
ON
1 Flash = 1 second
1 Flash = 1 second
3 second (Default)
2 seconds (Default)
MEDIUM
OFF (Default)
LOW
MODE 2
MODE 3
OFF (Default)
-
1
-
2
STATUS
VALUE
3
4
1
2
-
-
1
1
1
1
2
3
2
2
2
3
3
4
4
-
-
-
-
-
-
-
-
-
-
-
-
-
Courtesy Light
10
11
7
8
9
6
1 Flash = 10 seconds
120 seconds (Default)