Installation manual

The R3 & R5 rotary swing gate systems are designed to open and close swing gates. The CP75 controller
is capable of handling both single and double swing gates and offers many features to suit almost any
application.
Detailed specifications for the R3 & R5 motors are shown in the figure below and the table alongside.
The unit employs a battery driven DC motor for low duty domestic applications, which provides automatic
backup protection in the event of a power failure. The unit can also be fitted with a high duty power supply
in addition to the battery to allow for more frequent operation of the gate.
The R3 & R5 operators are fitted with an internal electronic limit switch system, which provides reliable
and accurate positioning of the gate. This system allows the operator to smoothly slow the gate down at
the fully open or closed positions.
A fail-safe and highly reliable collision sensing system is built into the controller, which will cause the
motor to stop while the gate is opening, and stop and reverse when closing if a gate is obstructed in any
way. (The collision sensitivity will be reduced during the endpoints of sinusoidal motion).
Gate movement is transmitted to the gate by means of articulated arms. The length of both the drive arm
and the connecting arm is easily adjusted to give maximum installation flexibility.
Specifications
General DescriptionGeneral Description
Figure 1 Overall Dimensions
220mm
100mm
337mm
234mm
Page 8
337mm
110mm 220mm
237mm
110mm
SPECIFICATION R3 R5
Input Voltage* 220V AC ±10% 50Hz 220V AC ±10% 50Hz
AC Current draw (with C84E Battery Charger) 120mA 120mA
DC Motor Voltage 12V 12V
DC Current draw (Max) 30A 35A
Maximum solenoid lock current draw 2A 2A
Output shaft rotational speed 3.5 rpm 2.6 rpm
Maximum output torque 95Nm 250Nm
Mass of master motor kit (excluding pedestal or wall bracket) 14.4kg 15,5kg
Mass of slave motor kit (excluding pedestal or wall bracket) 12.9kg 14,0kg
Maximum number of operations per day (Average):
Light industrial, with 10A power pack (PSU) 100 250
Domestic, with 1A Battery Charger (CP84E) 20 20
Maximum number of continuous operations 20 100
Typical time to open/close a gate 10 seconds 13 seconds
(For standard pedestal in recommended position)
No. of operations on a 7A/H battery (should the mains power fail) ±20 ±20
Limit switches Sealed optical counter Sealed optical counter
with origin switch with origin switch
Collision sensitivity Electronic adjustable Electronic adjustable
Temperature range -20º to +50ºC -20º to +50ºC
Housing protection IP55 IP55
Control card (single or double motor) CP75 CP75
Corrosion protection (baseplate and arms) Zinc passivation with Zinc passivation with
lacquer impregnation lacquer impregnation
Page 9
*Other voltages are available