User guide

ACTIONCAUSESYMPTOM
input LED's are OFF. They
must only light up when the
corresponding input is
activated.
!
Try operating the system
using the TEST pushbutton
on the control card.
!
Consult your installer if the
problem persists
!
!
!
!
!
Check that the GREEN LED
adjacent the IRB input is ON
When the IRB input is ON
Then the infra red beam is
clear.
Check that beam is correctly
aligned. It should be possible
to hear the relay "click" as the
beam is broken and cleared.
Ensure that nobody is
mistakenly pressing and
holding down the gate
release pushbutton on either
the remote or intercom for
too long when activating the
unit. Refer to section Auto-
close override.
!
!
!
Check the GREEN IRB LED
on the controller. It must
remain ON if the beam is
clear.
Consult your installer if the
problem persists.
Unhook the gate from the
mechanical linkage and
check that the operator then
drives fully closed. Consult
your installer if the problem
persists.
!
Check that the origin sensor
which is mounted on the
black plastic housing which
covers the manual override,
is properly clipped in.
!
Gate does not auto-close.
!
Gate starts closing but stops
and re-opens.
!
Operator drives too far and
does not stop in the correct
open and closed positions.
!
Infra red beam (if fitted) is
faulty.
!
Intermittent operation of infra
red beam if fitted.
!
Origin system not functioning
correctly.
!
Anti-crushing device is set
too sensitively.
!
Check that the auto-close
override facility is not being
operated.
Page 21