Manual

Illustration #14
STEP 10: Pull out the trigger pin on the
right side of the pistol. The trigger
assembly may now be removed.
Illustration #15
Illustration #16
STEP 12: Using a thin metal punch, pull out the hammer pin on the right
side of the pistol. The hammer assembly may now be removed.
To reassemble the pistol, follow the disassembly steps in reverse order.
When putting your pistol away for storage, it should be thoroughly cleaned and lightly lubricated. Outside
surfaces should be wiped with a light coat of good quality gun oil. CHECK TO ENSURE YOUR FIREARM
IS UNLOADED BEFORE PUTTING IT AWAY FOR STORAGE BY VISUALLY EXAMINING BOTH ITS
CHAMBER AND MAGAZINE. Store the firearm in a separate location from its ammunition. When the
firearm is to be reused, remove all excess lubrication before firing. Make certain that the bore (inside of
barrel) is dry and free of obstructions before firing.
Note: The use of reloaded, re-manufactured, hand-loaded, or other non-standard ammunition may result
in damage to the pistol and injury to the shooter and/or bystanders. The manufacturer and importer
cannot accept responsibility for malfunctions resulting from the use of non-standard, defective
ammunition.
Page 10 © Century International Arms, Inc. Shooters Arms Model X9 Pistol
X9 Pistol Disassembly
STEP 11: If it becomes necessary to remove
the hammer assembly, use a metal punch to
remove the c-lock washer (situated on the
left side of the pistol) of the hammer pin.
Magazine Dis-Assembly
Should the pistol’s magazine become fouled with shooting residue, it will need to be dis-assembled. and
cleaned. To do so, follow the instructions below:
WARNING! The X9 pistol’s magazine contains a spring which is kept under great
tension. You should wear eye protection, such as shooting glasses or goggles when
disassembling and reassembling your pistol’s magazine to protect your eyes from the
mainspring which could become dislodged during the following procedures.
Using a metal punch, depress the stud in the magazine’s floor plate while sliding the floor
plate from the magazine body. Keep a finger over the open magazine’s base to prevent the
mainspring (which is under tension) from flying out. Keeping the magazine’s base pointed in
a safe direction, slowly allow the main spring to release from the magazine body by covering
it with and catching it in your other hand. Thoroughly clean and lightly oil all parts.
Reassemble in reverse order of disassembly.