Instruction manual

Robinison 22HP Manual

Step 8 CCPM (cyclic collective pitch mixing) Swashplate Assembly

Starting with the inside race, apply threadlock and attach two short balls (Tip 1) directly across from each other,

similarly attach two medium balls to the remaining holes. Attach three short balls (Tip 2) to the outside race, each 120

degrees apart. The extra location is used for the anti-rotation bracket assembled later.

Step 7 Washout Assembly

Attach two Medium Balls (Tip 2) to the Washout Mixing Arms (

note they are attached from the flat side of the arm).

Using one slide tube inserted from the flat side, secured using one M3x16 Button Head Screw and one 3x7mm Flat

Washer per arm. Do not overtighten the arm as it is threaded into the plastic washout base. Also note, the screw is

attached on the left when installed later on the main shaft. Press the radius link on to the inner short balls on the

swashplate.

#HI3152C

Washout Arm

x 2

#HI3152A

Radius Arm with Pin x 2

#HI3152C

Slide Tube x 2

#CNLR1015

Medium Ball x 2

M3x16 Button

Head Screw x 2

M3x7 Flat

Washer x 2

Pre Assembled in Kit

#HI3146C

CCPM Swashplate

#CNLR1014

Short Control Ball x 5

#CNLR1015

Medium Control Ball x 2

Short Control Ball

Plastic Anti-rotation pin &

M3x16 Socket Screw