Use and Care Manual

507713-01Page 24 of 32 Issue 1623
FAILURE CODES
Figure 34
Integrated Control
(Automatic Hot Surface Ignition System)
Integrated Control Diagnostic Codes
NOTE: This control is equipped with a push button switch
for diagnostic code recall. The control stores the last 5 fault
codes in non-volatile memorty. The most recent fault code
is ashed rst, the oldest fault code is ashed last. There is
a 2 second pause between codes. When the push button
switch is pressed for less than 5 seconds, the control will
ash the stored fault codes when the switch is released.
The fault code history may be cleared by pressing the push
button switch for more than 5 seconds.
Figure 33