Instruction Manual Para instrucciones en Español, llamar al: 1-800-837-4044 www.centuryproducts.
TABLE OF CONTENTS This instruction manual is for: • Breverra Ascend DX Booster Car Seat • Breverra Ascend SE Booster Car Seat Instructions for these models are the same unless otherwise noted. Operations and Adjustments ..............................12 • Harness Straps • Harness Tie • Buckle • Tether Strap • Changing Harness Strap Slots Harness System removal and re-assembly.....................14 ❃ Before You Begin Important Information.....................................1 Warnings......................
IMPORTANT INFORMATION No car seat can guarantee protection from injury in every situation, but proper use helps reduce the risk of serious injury or death. ❃ Safety First Check List ✔ Read and understand instruction manual and car seat labels. ❃ Registration Information Child restraints (car seats) could be recalled for safety reasons. You must register this restraint to be reached in a recall.
WARNINGS - Prevent serious injury or death: x Failure to follow these instructions and car seat labels can result in child striking the vehicle’s interior during a sudden stop or accident. Secure child restraint with a vehicle seat belt as shown in this manual. Not all vehicle seat belts can be used with car seat.
WARNINGS - Prevent serious injury or death (continued): DO NOT use car seat if it is damaged or has missing parts. DO NOT use accessories or parts other than those provided by Century or Graco. Their use could alter the function of the car seat. Never leave child unattended, even when sleeping. If car seat has a cup holder, DO NOT put hard or sharp objects in cup holder.
BASIC INFORMATION ❃ Certification ❃ Unoccupied Car Seat With Harness System: Car seat meets or exceeds all applicable requirements of Federal Motor Vehicle Safety Standards for use in motor vehicles and aircraft. Always secure car seat with a vehicle seat belt, even when unoccupied. An unsecured car seat can injure passengers. Without Harness System: Booster seat is certified for use in motor vehicles. Booster seat is NOT certified for use in aircraft.
HEIGHT and WEIGHT LIMITS ❃ With Harness System ❃ Outgrowing Car Seat Child MUST meet all of the following requirements: • Weight is 30 - 40 lbs. (13.6 - 18 kg). • Height is 27 - 43 inches (68.6 - 110 cm) tall. • Child is able to sit upright unassisted. WARNING To avoid injuries from whiplash, top of child’s ears must be below top edge of headrest. • Child’s shoulders are not above top harness slots. With Harness System 40 lbs. 30 lbs. {13.6 kg} {18 kg} 80 lbs. {36.
INSTALLATION - with harness system 1 2 3 Place forward-facing on vehicle seat. Lift seat pad flap, thread vehicle seat belt through openings and buckle belt (fig. a). Press down firmly in center of car seat to compress vehicle seat cushion while tightening vehicle seat belt. HINT: Use your knee to press down in center of car seat (fig. b). 4 Pull front to back and left to right to check for secure installation (fig. c). Vehicle lap belt MUST stay tight. If not secure, see “Vehicle Seat Belts” section.
INSTALLATION - without harness system 1 2 Place forward-facing on vehicle seating position with a vehicle lap/shoulder belt. See “Vehicle Seat Belts” section. Tether may be used to stabilize booster seat: Attach tether hook (A) to anchor hardware (B) and tighten strap to remove any slack (fig. a). If tether anchor hardware (B) is not available, see “Installation of Anchor Hardware“ section. If not using tether, see “Tether Storage” section. Pull to tighten (A) (B) (fig.
PLACING CHILD IN CAR SEAT - with harness system Adjust harness system: WARNING Harness straps must be through slots at or just above shoulders. To prevent serious injury or death: • Vehicle seat belt must be routed through back of car seat when using harness system. • Never place vehicle belt in front of child when using harness system. 1 2 • Do not use strap covers, blankets, cushions, or padding under harness straps or child unless provided by Century or Graco.
PLACING CHILD IN CAR SEAT - with harness system (continued) 3 2 (fig. a) (fig.
PLACING CHILD IN CAR SEAT - without harness system Remove harness system (see “Harness System removal and re-assembly” section). WARNING To prevent serious injury or death: • Shoulder belt MUST be properly positioned over shoulder (NOT touching child’s neck and NOT low off shoulder). • Lap/shoulder belt MUST be properly positioned exactly as shown in illustration with lap belt under both armrests and shoulder belt over one armrest.
PLACING CHILD IN CAR SEAT - without harness system (continued) Loops (fig. a) (fig. b) (fig.
OPERATIONS and ADJUSTMENTS 1 Harness Straps: • To tighten: Pull belt tab (fig. a). • To loosen: Lift lever on front of car seat while pulling harness straps (fig. b). 5 Changing Harness Strap Slots: MUST use slots at or just above shoulders. A Loosen harness straps: • Lift lever on front of car seat. 2 • Pull harness straps. Harness Tie: • To open: Press tab and pull apart (fig. c). • To close: Snap halves together. Make sure harness tie is locked by pulling out on each half.
OPERATIONS and ADJUSTMENTS (continued) 2 3 1 (fig. e) (fig. a) Loosen Tighten Adjuster (fig. b) (fig. c) (fig.
HARNESS SYSTEM - removal and re-assembly Removal: Re-assembly: When re-assembling harness system, be sure harness straps are not twisted. Harness with Breast Plates: • Remove harness strap loops from Splitter Plates on back and bottom of car seat. 1 Harness with Breast Plates: Thread Splitter Plate and looped end of harness straps down through slots in seat pad, under both Clips on bottom and slide harness strap loop through Splitter Plate slot. • Pull harness strap out of car seat.
HARNESS SYSTEM - removal and re-assembly (continued) (Harness with Breast Plates) (Harness without Breast Plates) 3 Splitter Plate (Bottom) 3 5 5 (Clip) 2 2 1 1 (Clip) 4 Splitter Plate (Back) (Clip) (Clip) 15
VEHICLE SEAT BELTS WARNING Not all vehicle seat belts can be used with a car seat: • Car seat with harness system MUST be held securely at all times by a lap belt (or lap belt portion of a lap/shoulder belt) that will not change length while driving. • Car seat without harness system MUST be used with a lap/shoulder belt. To provide the best installation of the car seat: • Read the vehicle owner’s manual regarding car seat installation and seat belt use with car seat.
VEHICLE SEAT BELTS (continued) ❃ Lap Belts - Manually Adjustable With Harness System: The locking latch plate on some seat belts may slip and loosen after being buckled on car seat if positioned at a certain angle. If this happens, flip latch plate over (fig. a) and re-buckle. Test installation again to see if this works. If not, move car seat to another seating position. Flip Without Harness System: DO NOT use this type of vehicle seat belt to secure child and booster car seat. (fig.
VEHICLE SEAT BELTS (continued) ❃ Lap Belts - With Retractor With Harness System: Lap belts with retractors may or may not hold a car seat securely. Follow these steps to determine if you have a retractor system that will hold car seat securely: a. Pull belt all the way out. b. Allow belt to retract about 6 inches (15 cm). c. Pull out on belt again. If belt is locked and you cannot pull the belt out any further, you have an Automatic Locking Retractor which may be used with a car seat.
VEHICLE SEAT BELTS (continued) ❃ Passive Restraint - Lap Belt with Motorized Shoulder Belt With or Without Harness System: DO NOT use with any car seat. ❃ Passive Restraint - Lap or Shoulder Belt Mounted on Door With or Without Harness System: DO NOT use with any car seat. Belts will not stay tight while driving.
VEHICLE SEAT BELTS (continued) ❃ Belts Forward of Seat Crease Seat Crease With Harness System: Vehicle seat belts located forward of seat crease may not securely hold car seat. Check vehicle owner’s manual or see vehicle dealer for car seat installation requirements. If approved for use with car seat by vehicle manufacturer, install car seat and check for secure installation by pulling car seat front to back. If car seat slides forward, DO NOT use these seat belts. Without Harness System: OK to use.
VEHICLE SEAT BELTS (continued) ❃ Combination Lap/Shoulder Belt with Locking Latch Plate With Harness System: Flip OK to use. Follow vehicle owner’s manual for specific instructions on how to use vehicle seat belts. The locking latch plate on some seat belts may slip and loosen after being buckled on car seat if positioned at a certain angle. If this happens, flip the latch plate over (fig. b) and re-buckle. Test installation again to see if this works. If not, move car seat to another seating position.
VEHICLE SEAT BELTS (continued) ❃ Combination Lap/Shoulder Belt with Sliding Latch Plate With Harness System: Pull Pull on latch plate (fig. a). If belt slides freely through latch plate, a locking clip MUST be used. (See “Locking Clip”section.) (fig. a) Without Harness System: This vehicle seat belt system is OK to use with booster car seat.
VEHICLE SEAT BELTS (continued) ❃ Locking Clip WARNING Avoid serious injury or death: • Failure to use locking clip where required will result in car seat not being securely held in place. • Remove locking clip from seat belts when not being used with car seat. When using car seat with harness system, you MUST use locking clip provided with car seat with a vehicle seat belt that slides freely through the latch plate or the lap belt cannot be tightly secured.
ADDITIONAL INFORMATION ❃ Installation of Anchor Hardware Vehicle may already be equipped with a tether anchor (top strap anchor). See vehicle owner’s manual for location. If vehicle does not have a tether anchor, one must be installed: • Contact vehicle dealership for proper anchor location and installation. WARNING Avoid serious injury or death: • Be sure anchor hole is properly sealed to prevent exhaust fumes and water from entering the vehicle.
ADDITIONAL INFORMATION (continued) ❃ Tether Storage For storage of tether hook if not used with a belt position booster: • Adjust tether strap length so hook end is as short as possible. • Roll loose end of strap up. • Place rolled up strap on top of adjuster and place rubber band around bundle. ❃ Cup Holder Available on some models: • Locate slot in armrest and armrest pad on either side of car seat. • Snap cup holder into slot of armrest.
ADDITIONAL INFORMATION (continued) ❃ Care & Cleaning Removing Seat Pads: If using harness system, remove harness system (see “Harness System - removing and re-assembly” section). 1 Turn car seat upside down: Using a screwdriver, pry metal rod loose from car seat shell and slide elastic off. 1 CAUTION: Be careful not to damage webbing with screwdriver. Rod can be re-installed by pressing firmly or tapping with hammer. 2 Turn car seat upright: 2 Unhook elastic from “J” hooks and pull seat pad off.
ADDITIONAL INFORMATION (continued) Removing Cup Holder: • Feel bottom of armrest and locate tab on bottom edge of cup holder. • Press tab in while lifting cup holder up.
ADDITIONAL INFORMATION (continued) Seat Pad and Armrest Pads: Machine-wash separately on gentle cycle and machine-dry on cool air setting or line dry. WARNING Prevent serious injury or death: • Buckle must be properly latched. Harness Straps: Surface wash only with mild soap and damp cloth. If harness straps are frayed or heavily soiled, they MUST be replaced. Shell: Wipe with mild solution of soap and water. Avoid wetting labels. Never use “household detergents”: they can weaken plastic.
ADDITIONAL INFORMATION ❃ Aircraft Use With Harness System: This car seat is certified for use on aircraft when used with harness system (see label on car seat). Contact airline about their policy. (continued) ❃ Second Hand Car Seat Century advises against loaning or passing along car seat. Use this car seat only on forward-facing aircraft seats. Install car seat on an aircraft the same way it is installed in a vehicle except DO NOT use tether strap.
1 2 Fold instruction manual. Store in pocket. Pocket If a part is damaged, missing, or you need help or replacement parts, DO NOT return car seat to the store. CALL US FIRST Call toll-free 1-800-837-4044 from anywhere in the U.S. or Canada or fax at 1-610-286-4555. or write us at: Century Products P.O.
