Installation Instructions Chapter 4
FibeAir 1500 Installation & Operation Manual Chapter 4. System Setup
4-4 The Setup Procedure Revision 2.0
4.2.3. Quick Setup
To perform quick setup, carry out the following operations:
1. From the Main Configuration Menu, select 1 – Quick Setup and press
Enter. The Quick Setup menu appears.
Note
: Quick Setup is the recommended option if you are not familiar with the system.
More advanced users may use the Full Configuration menu.
Figure 4-3 FibeAir 1500 Terminal - Quick Setup Menu
2. Accept or change each parameter value. Press Enter to accept the
existing value or type in the new value in the space provided.
— Ethernet IP address: The FibeAir 1500 Ethernet port IP address
you wish to use.
— Ethernet IP Mask: Your network IP sub-net address.
— Serial IP address: The FibeAir 1500 Serial port IP address you wish
to use.
— Serial IP Mask: Your network IP sub-net address.
— Default Router IP address: The FibeAir’s default router address.
— Read community: The community password for read only devices.
— Write community: The community password for read/write devices.
— Trap option: “0” – sending standard trap, “1” – sending trap with
unit serial I.D. The recommended option is “0”.
— Serial Type: Defines the serial communication type, PPP or SLIP.
— Serial Baud Rate: Serial communication port baud rate.
— Dial-Out Phone Number: The phone number to be dialed by the
indoor unit.