User's Manual Chapter 3

FibeAir 1500 Installation & Operation Manual Chapter 3. Installation
Revision 2.0 Installation Instructions 3-13
5. Click Apply.
The settings are saved in the IDU configuration. From this point on, the
ODU is set to the desired frequency.
6. Click Cancel to close the window.
The Frequency Plan window is closed and you are returned to the Work
Area window.
3.9.11. Setting Transmitted Power, Antenna Diameter and Operating Distance
If the Tx power level was previously defined using the HyperTerminal, use
this screen only to verify that the correct power was set.
You can perform the following in the ODU configuration window:
■ Set transmitter power levels or mute it.
■ View the current received level (RSL).
■ Set antenna size and link distance to determine the expected RSL (in
RSL graph and radio performance monitoring window).
■ View ODU temperature graph.
After setting the link, you can set the parameters in ODU configuration
window, for both local and remote ODU’s.
1. Select Configuration ½ ODU.
The ODU Configuration window is displayed.
Figure 3-10 ODU Configuration window