User's Manual Chapter 3

FibeAir 1500 Installation & Operation Manual Chapter 3. Installation
Revision 2.0 Required Components and Equipment 3-3
3.5.2. Required Tools
The following tools and equipment are needed to install an ODU:
■ 4 x N-type connectors (according to cable type)
■ Coaxial cable
■ Insulation tape
■ Ratchet wrench (3/8” Drive)
■ 10mm nut driver
■ 13mm socket (3/8” Drive)
■ 13mm open/box end wrench
■ Phillips screwdriver
■ Sharp cutting knife
■ Compass (optional)
■ Torque wrench
■ Digital voltmeter
■ Giganet optical view finder (optional)
3.5.3. Local Management PC Hardware Requirements
Before you install the GiganetView software, verify that your PC has the
minimum requirements as follows:
Processor Pentium (200 MHz minimum)
Memory (RAM) 32 MB minimum
Operating System Windows 95/98/NT
Display Monitor 800 x 600 minimum, 16,384 colors maximum
Keyboard
Mouse
Serial Port RS-232