User's Manual Chapter 3

FibeAir 1500 Installation & Operation Manual Chapter 3. Installation
Revision 2.0 Installation Instructions 3-37
2. Make sure that the fittings and the coax cable are clean and dry.
3. Peel approximately 6 inches of COAX-SEAL from the paper backing.
4. Wrap isolation tape over the coax cover. Start winding from coax cover
towards fitting with one half overlap with each winding making sure all
joints are well covered.
Figure 3-36 Steps 1, 2 & 3
5. After entire fitting and coax cable are covered with approximately 3/16"
thick layers, mold and form COAX-SEAL with fingers to make a smooth
surface and force out any air.
Figure 3- 37 Step 4
6. If more COAX-SEAL is necessary to complete seal simply cut the
needed amount and add to existing COAX-SEAL, molding and press into
the other material. COAX-SEAL adheres to itself with slight pressure.
Carefully inspect seal to make certain that all joints are covered