User's Manual Chapter 3

Chapter 3. Installation FibeAir 1500 Installation & Operation Manual
3-4 Suggested Pole Installation Revision 2.0
3.6. Suggested Pole Installation
The antenna can be installed on a ground tube, roof, or wall mount. The
ground tube or roof/wall mount should be assembled and in place before
installing the antenna mount.
Figure 3-1 Calculating Required Pipe Diameters
Use the following table to determine the pipe diameters:
Table 3-1 Wind Loading
Antenna Size 1 ft. (30 cm)
2 - 2
1
/
2
ft.
(60 - 75 cm)
4 ft.(120 cm)
Minimum Pipe Diameter 50 mm 65 mm 115 mm
Wind Velocity 200 km/h 200 km/h 200 km/h
F
AT, max.
[N] 303 929 2821
F
ST, max.
[N] 150 460 1398
M
T, max.
[Nm] 47 283 894
After determining the pole size, verify that you have the required bolt for the
antenna mount.
Table 3-2 Required Bolt size
Pipe Diameter [mm] Bolt size [mm]
48 - 51 51
52 - 89 89
90 - 115 115