User's Manual Chapter 3

Chapter 3. Installation FibeAir 1500 Installation & Operation Manual
3-8 Installation Instructions Revision 2.0
3.9.4. Installing the GiganetView Management Software
1. Insert the “GiganetView” CD into your CD drive.
2. Via Windows Explorer or the File Manager, double-click on the
“setup.exe” file.
The installation program begins installation.
3. Follow the instructions displayed.
The full installation procedures are included in the Appendix A.
Note
The recommended resolution is 1024 x 768.
3.9.5. Connecting to the Ethernet Port
1. Connect a crossed Ethernet cable from your PC to the Ethernet Port. If
the connection is to a LAN (wall connection) use the standard Ethernet
cable.
Figure 3-3 Crossed and Straight Cable
2. Make sure the IP address on your PC is on the same sub-net as you
defined in the FibeAir indoor unit (i.e. in most cases, the first three
numbers of the IP address must be identical, depending on the sub-net
mask).
3. Run the GiganetView software from your computer.
3.9.6. Connecting to a PPP/SLIP Port
Remove the IDU cable from the TERMINAL port and connect it to the
SERIAL port (RS-232).
3.9.7. Installing a PPP/SLIP Driver
Install a PPP/SLIP driver in your computer. Refer to Appendix A for details
of installation in Windows 95 and NT.
The installation of the PPP/SLIP driver is needed only for the first time that
you operate the computer.