Other
CERNOGROUP.COM 949.715.1534 1751 MCGAW AVE, IRVINE, CA 92614
Proper care and maintenance
of your Cerno® product
CLEANING: Wood surfaces should be dusted and cleaned with a damp
cloth.
Every 1 - 3 years, re-oil and wax wood surfaces to maintain the rich
wood sheen. Remember to wipe with the wood grain, and remove any
excess oil or wax when nished.
Regularly maintaining your Cerno® product is easy and will help keep it looking beautiful. Scratches can be bued
out in minutes. Wood surfaces will be revitalized with minimal eort every few years. The LED light source is rated
to last 50,000 hours, and should last the life of the product.
Cerno® products include a 2 year performance guarantee warranty. In addition to Cerno’s warranty, Cerno oers
an in-house repair service for the life of the product. Note that some materials cannot be repaired.
CLEANING: Everyday cleaning of metal surfaces can be done with a damp
cloth.
Oiled Walnut
Brushed Aluminum
CLEANING: To clean frosted acrylic surfaces, use a damp cloth with soap
and water or typical cleaners. Avoid heavy-duty cleaners (i.e. anything
solvent-based), as they can damage the acrylic.
Frosted Acrylic
CLEANING: Wood surfaces should be dusted and cleaned with a damp
cloth.
Wax every 1 - 3 years, taking care to wipe with the grain. Remove any
excess wax when nished.
Dark Stain Walnut, Baltic Birch
CLEANING: Burlap and Linen - Blow away dust and dirt particles with
compressed air. Avoid using water or a vacuum to clean burlap or linen
shades.
Ebony and Birch - Treat these shades as Veneer (see below).
Shade Material
Recommended products
Watco Danish oil Howard Feed n’
Wax
Compressed Air
CLEANING: When cleaning veneer, take care not to peel the edge as it can
de-laminate the veneer.
Wax every 1 - 3 years. Remove any excess wax when nished.
Veneer
Damp Cloth
Howard Feed n’
Wax
Damp Cloth
Scotch-Brite
(for repairs)
Damp Cloth
200 - 300 Grit
Sandpaper
(for repairs)
Howard Feed n’
Wax
Damp Cloth
REPAIR: To remove scratches from brushed aluminum, use Scotch-Brite
(Gray or Maroon) to bu the scratched area. In a pinch, you can use the
rough side of your kitchen sponge.
REPAIR: Scratches can be bued out of acrylic surfaces using 200 - 300
grit sandpaper.
CLEANING: Everyday cleaning of metal surfaces can be done with a damp
cloth.
Black Anodized Aluminum
Damp Cloth
Damp Cloth