Instructions

ManualsBrandsCerno ManualsLightingVix 5 - Light Kitchen Island Linear LED Pendant with Wood Accents

Linear Pendant

Installation Instructions

CERNOGROUP.COM T_949.715.1534

2139 1/2 LAGUNA CANYON RD. LAGUNA BEACH CA 92651

1.25"

4.5"

1.25"

4.5"

General Product information

This product is suitable for indoor dry locations only.

This product can be dimmed with most standard dimmers.

Please see “Dimmer Compatibility” section of these

instructions for more information.

CAUTION - RISK OF FIRE

This product requires installation by a qualied

electrician. Before installing be sure to read

all instructions and TURN POWER OFF TO THE

JUNCTION BOX

Adjusting the

Fixture Height

Measure the desired

height (H )that you

want the xture to

hang below the ceil-

ing.

Thread the cables

through the canopy

fasteners, canopy,

crossbars, and wash-

ers.

Tie a knot in the cable

at the desired length H

110V AC Electrical Service

LED Driver

Crossbar

Canopy

Backplate

LED Light Engine

Canopy Fastener

Shade

White (NEUTRAL)

Black (HOT

)

Red (+)

Black (-)

Washer

Figure 1

Figure 2

Summary of content (3 pages)

PAGE 1
Linear Pendant Installation Instructions Adjusting the Fixture Height General Product information 1 Measure the desired This product is suitable for indoor dry locations only. height (H )that you want the fixture to hang below the ceiling. This product can be dimmed with most standard dimmers. Please see “Dimmer Compatibility” section of these instructions for more information. 4.5" 1.
PAGE 2
Linear Pendant Installation Instructions Figure 2 4 6 5 Figure 3 Mounting the Fixture 4 Feed the power line wires through the hole in the center of the backplate. 5 Mount the backplate to the electrical box with the supplied #8-32 screws. 6 Secure the backplate to the ceiling using the additional mounting holes. Making Electrical Connections 7 Make electrical connections as shown in figure 2 using the supplied wire nuts.
PAGE 3
Linear Pendant Installation Instructions Securing the Canopy 8 After electrical connections have been made, place all of the wires inside of the junction box. 8 9 Slide the canopy up the 9 9 cables and secure it by screwing the canopy fasteners into the crossbars. 10 Install the shade 10 Figure 4 Dimmer Compatibility The LED driver included with this fixture is designed to operate with most standard dimmers. Extensive testing with the dimmers listed below has been conducted.