Installation Instructions

CertainTeed Vinyl Siding Installation Guide

107

Angle the panel into the cornerpost and slide to the left until the

side tabs clear. Next, slide the panel to the right until you have the

correct temperature marks on the panel lined up.

Install the top section of Mitered Cornerpost. Leave 1/4" between

the top corner piece and the cornice receiver.

NOTE: Depending upon the area of the D9 Staggered

Rough-Split panel you ﬁnish with, you may have to install

furring behind the cornice receiver to accommodate the

thickness of the Rough-Split panel.

Snap the cornice molding into the cornice receiver. The cornice

molding should be 1/4" from the edge of the wall.

Hook the top of the cornice cap over the end of the cornice

moldings and snap the bottom into place. Alternately, you can

slide the cornice cap over one of the cornice moldings until the

other cornice molding can be inserted.

cornice cap

1/4" from the edge

cornice receiver