Installation Instructions

CertainTeed Vinyl Siding Installation Guide

123

Push on the back button of the snap rivet to secure the clip to the

panel. Repeat over each locking tab area.

Place the heavier part of the cam clip up against the cam.

While applying pressure to the top panel, pull down on the

thinner end of the clip.

Installing the new panel

Slide the left side of the new panel into the side locking tabs.

To engage the right side tabs into the existing panel, ﬂex the

panel out from the center. As you raise the new panel into

position, make sure the bottom lip of the panel engages the

locking tabs on the panel below.

Lift up the panel above the new panel far enough to place the

nails into the old nail holes.

Using your wonder bar or roof snake bar, drive the nails in by

placing the bar on the nail head and hitting the bar with a hammer.

Place the heavier part of the cam clip up against the cam. While

applying pressure to the top panel, pull down on the thinner end

of the clip. Make sure each cam clip engages the lip of the panel

above it. Keep pulling down on the cam cords until they break off.