User's Manual

certgate GmbH
17 / 17
Firmware update via USB
7. Safety Instructions
Protect the device from dirt, dust, moisture, chemicals and extreme temperatures and use it only in dry rooms.
Use only original, approved accessories intended for this purpose for the device.
Do not use the product in the immediate vicinity of heating, other heat sources or in direct sunlight.
Do not expose the device directly to magnetic sources.
Do not drop the product and do not expose it to violent shocks, drops, shocks or vibrations of any kind.
Do not attempt to service or repair the product yourself or have it serviced or repaired by an unauthorized service or person.
Do not make any unauthorized modifications to the software or hardware.
Do not open or operate the product if damaged.
Improper use may damage the product or connected devices.
To charge the battery, use only standardized charging cables and power sources (5V DC) to avoid overcharging. This could damage the battery.
8. Disposal and Recycling
The device must not be disposed of with household waste. B2B equipment must be returned to the manufacturer.
9. Maintenance and Care
Clean the device only with a soft, clean and dry cloth. Do not expose the device to harsh chemicals, cleaning solutions or strong cleaning agents. Do not
allow liquid to penetrate the product.
10. Warranty/ License/ Technical Support
Please note our regulations at Terms and Conditions & Legal Documents
Please note that only customer with a valid support and maintance agreement are authorized to get free support services.
including the antenna, third-part-belt-clips, holsters, and similar accessories used by this deivce
a minimum separation distance of 5mm must be maintained between the user's body and
This device was tested typical body-worn operation, to comply with RF exposure rquirements,
1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
2. Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
-Consult the dealer or an experienced radio/TV technician for help.
AirID
ishould not contain any metallic components.